
20192020 Undergraduate Catalog
Computer Engineering (BCpE)


Return to: College of Engineering Return to Department 
College Requirements:
 The College of Engineering requires nine additional breadth credits (21 credits total including the University Breadth requirements) (minimum grade of C).
 These nine credits may be selected in any combination from the University Breadth Requirements list and the College of Engineering Breadth Requirement List in any category except Math, Natural Sciences and Technology.
 Of the 21 credits, six credits must be at the Upper Level, defined as:
 any 300level or higher course on the University Breadth Requirement list (excluding Math, Natural Sciences and Technology courses)
 any 300level or higher course on the College of Engineering Breadth Requirement list (excluding Math, Natural Sciences and Technology courses)
 any foreign language instruction course at the 107 level or higher as designated on the College of Engineering Breadth Requirement list (some courses above the 107 level do NOT count toward this requirement because they are taught in English).
 A maximum of two courses (six credits) can be taken from the Career and Professional Preparation subsection of the College of Engineering Breadth Requirement list to satisfy the College of Engineering additional breadth requirement.
 Of the 21 credits, three credits may be used to satisfy the University Multicultural Requirement (recommended for timely progress toward degree completion.)
 With few exceptions, students may not use courses from their major to satisfy Breadth Requirement coursework.
IMPORTANT NOTE: Courses taken from the College of Engineering Breadth Requirement list can ONLY count toward the additional nine credits of breadth the College of Engineering requires for its majors. They CANNOT count for University Breadth.
Academic Standards
Students pursuing any engineering major (except Computer Science or Information Systems) must have at least a 2.0 grade point average in all engineering, mathematics, and science courses used to fulfill graduation requirements. If a course is repeated, only the last grade will be used to compute the engineering grade point average; all grades are used to compute the University’s cumulative grade point index. Credit from courses taken pass/fail cannot be used to complete any engineering degree requirement, unless the course is only offered pass/fail in the engineering curriculum.
Foundation Elective:
One of the following: Design Requirement (DLE):
In addition to the normal program, every student must take six credits in a CPEG course designated as “design”. Senior Design I, CPEG 498 (three credits) will be offered in the fall semester and Senior Design II, CPEG 499 (three credits) will be offered in the spring semester. Technical Electives:
 Six credits in 400level or above ELEG or CPEG courses
 Six credits in approved general technical electives.
 Approved general technical electives are mathematics, science, computer science, and engineering courses with technical content typical of a 300level or above engineering course.
Electives not listed must be formally submitted and approved by the Associate Chair for Undergraduates. The list below includes frequently selected approved general technical electives: Electives:
After required courses are completed, sufficient elective credits must be taken to meet the minimum credit requirement for the degree.
Credits to Total a Minimum of 125
Last Revised for 20192020 Academic Year

Return to: College of Engineering

