Jan 25, 2022
Return to Department
- The College of Engineering requires nine additional breadth credits (21 credits total including the University Breadth requirements) (minimum grade of C-).
- These nine credits may be selected in any combination from the University Breadth Requirements list and the College of Engineering Breadth Requirement List in any category except Math, Natural Sciences and Technology.
- Of the 21 credits, six credits must be at the Upper Level, defined as:
- any 300-level or higher course on the University Breadth Requirement list (excluding Math, Natural Sciences and Technology courses).
- any 300-level or higher course on the College of Engineering Breadth Requirement list (excluding Math, Natural Sciences and Technology courses).
- any foreign language instruction course at the 107 level or higher as designated on the College of Engineering Breadth Requirement list (some courses above the 107 level do NOT count toward this requirement because they are taught in English).
- A maximum of two courses (six credits) can be taken from the Career and Professional Preparation sub-section of the College of Engineering Breadth Requirement list to satisfy the College of Engineering additional breadth requirement.
- Of the 21 credits, three credits may be used to satisfy the University Multicultural Requirement (recommended for timely progress toward degree completion).
- With few exceptions, students may not use courses from their major to satisfy Breadth Requirement coursework.
IMPORTANT NOTE: Courses taken from the College of Engineering Breadth Requirement list can ONLY count toward the additional nine credits of breadth the College of Engineering requires for its majors. They CANNOT count for University Breadth.
Students pursuing any engineering major (except Computer Science or Information Systems) must have at least a 2.0 grade point average in all coursework that counts toward the Engineering Grade Point Average as seen on the degree audit. This coursework generally consists of engineering, mathematics, and science courses used to fulfill graduation requirements. The college adheres to the university grade forgiveness policy. Outside of the timeframe specified in that policy, if a course is repeated, only the last grade will be used to compute the Engineering Grade Point Average. Credit from courses taken pass/fail cannot be used to complete any engineering degree requirement, unless the course is only offered pass/fail in the engineering curriculum.
Prescribed Breadth Courses:
- Complete two courses from the list of Professional and Career Preparation courses, these courses may also simultaneously satisfy College of Engineering breadth.
The six technical electives (eighteen credits) must satisfy the following requirements:
1. Technical electives will include courses from engineering, mathematics, and the sciences, or by the approval of the Civil Engineering Undergraduate Committee.
2. All technical electives must be 300-level or higher, or by approval of the Civil Engineering Undergraduate Committee.
3. At least four out of six technical electives must be 400-level or higher CIEG courses.
4. At least four out of six technical electives must be taken at UD.
Technical electives can be the below courses not otherwise used in the major core:
- BISC 300-699
- BMEG 300-699
- CHEG 300-699
- CHEM 300-699
- CIEG 300-699
- CISC 300-699
- CPEG 300-699
- ELEG 300-699
- GEOL 300-699
- MAST 300-699
- MATH 300-699
- MEEG 300-699
- MSEG 300-699
- PHYS 300-699
- STAT 300-699
- UNIV 401-402
CIEG Technical Electives Areas of Interest:
Civil Infrastructure Systems:
After required courses are completed, sufficient elective credits must be taken to meet the minimum credit requirement for the degree.
Credits to Total a Minimum of 125
Last Revised for 2020-2021 Academic Year